Reversing Camera – How to add aftermarket camera to IDCORE interfaces

Vehicles with Automatic transmission

On rear of IDCORE interface box ensure dip switch 8 is set to OFF (after any dip switch change, press the small reset button next to dip switches with a pin or similar) Turn car ignition ON, and select reverse gear. If you see a black screen when in reverse* – then wire camera as follows and picture should show

NOTE – for both front and rear camera inputs, only cameras with NTSC video output are supported.

Wiring – RED R.Rear 12v connects to power aftermarket camera – Plug camera video into yellow ‘Rear video‘ composite video connector

*If you do not see a black screen, this will mean that the interface box cannot get reverse data from your vehicle (e.g Audi with RMC/MMI Basic) – please follow instruction for manual transmission to get a picture.

Vehicles with Manual transmission –

On rear of IDCORE interface box ensure dip switch 8 is set to OFF, dip switch 4 set to ON (after any dip switch change, press the small reset button next to dip switches with a pin or similar)

Wiring – ORANGE REAR-C wire connects to vehicle reverse bulb (see car service for location/colour of this wire) R.Rear 12v connects to power aftermarket camera – Plug camera video into yellow ‘Rear video‘ composite video connector.

NOTE – If camera picture is unstable/black screen when engine running, this is caused by car CANBUS wiring fluctuating the voltage.

In this case, you can add a relay to solve – see guide below

Relay guide –

Suitable relay – 30/40 AMP 5 Pin 12V Auto Relay – widely available online

1) Locate a none CANBUS 12V source either directly from the battery or if available a rear 12V cigarette socket – Run a 12V cable with inline fuse from this connection to the installation area and finish with a female spade connector (to connect to the relay)

2) Attach a ground wire to a suitable earth point (you can use the same as the camera) and finish with a female spade connector.

3) Take the camera live and reverse switched live and finish with a female spade connector.

4) Connect a 12V wire to the live of the reverse lights (see live and reverse switch section above) and finish with a female spade connector. Now you have 4 female spade connections to connect to your relay – follow the diagram below for correct connection.

Auto-Display

If using in conjunction with an aftermarket rear view camera, front camera can display for 10 seconds after switching from reverse to forward gear.

To enable this mode, in IDCORE interface SETUP menu, switch FRONTVIEW to ‘ON’ – note this will not work if the car does not have an aftermarket camera connected to the IDCORE interface.

Switchable Display

Camera image can be manually displayed on screen using CarPlay entry button (i.e NAV) to switch in/out.

To enable this mode, in IDCORE interface SETUP menu, switch DVR to ‘ON’.